Related Manuals for Chamberlain GSD
Summary of Contents for Chamberlain GSD
- Page 1 SLIDE DOOR OPERATOR MODELS SD & GSD ADDENDUM 2 YEAR W A R R A N T Y NOT FOR RESIDENTIAL USE Serial # (located on electrical box cover) 41B6 Installation Date Wiring Type LISTED DOOR OPERATOR...
-
Page 2: Specifications
Door Travel plus 4’ - 3” 18” Min. 17.13” *Fusible Link Manual 17.46” Release FIGURE 1 Model GSD Cylindrical Weight Single Slide Door Layout 4” Adjustable clearance for door movement between 7.5” Max. wall and operator. 6.0” Min. 13.00” 13.08”... -
Page 3: Hardware Kits
PREPARATION 1. Unpack carton, checking for possible damage IMPORTANT during shipping. Damage claims must be filed with the freight carrier. Check that the nameplate data accurately specifies the operator that was ordered. This manual supplement includes only Verify that the following parts listed below are mechanical assembly instructions for your included in the carton. -
Page 4: Operator Assembly
OPERATOR ASSEMBLY The slide door operator should be pre-assembled as follows before installation: 1. Layout the two pieces of track on the floor, parallel Install two 3/8-16 x 1” hex bolts with lockwashers and to each other and install end idler shaft assembly nuts though the remaining two mounting holes in the (see page 5). -
Page 5: Mounting Assembly
MOUNTING ASSEMBLY FIGURE 4 IDLER SHAFT ASSEMBLY ANGLE MOUNTING BRACKET HEX HEAD BOLT, 3/8-16 x 1” LONG (2 PER BRACKET) FLATWASHER, 1/8” (2 PER BRACKET) TRACK SPACER BI-PART SLIDER CARRIAGE (SEE FIGURE 2) SLIDER CARRIAGE (SEE FIGURE 1) POWERHEAD HEX NUT, 3/8” (4 PER BRACKET) FIGURE 5 SERRATED FLANGE HEX NUT, #10 FLATWASHER, #10... -
Page 6: Operator Mounting
OPERATOR MOUNTING NOTE: Refer the figures on page 2 for general Check that the door clears the power head when information during this part of the installation. moving. Adjust the track hangers on the mounting brackets to the desired position and tighten all bolts. 1. - Page 7 NOTE: For bi-parting doors, it is necessary to bring 7. Adjust the screw collars on the disconnect pin so the doors to a fully closed position for proper that it enters into the trolley bracket about 3/4”. synchronization. With both disconnect pins and engaged in their respective carriages, lift the drive 8.
- Page 8 c 1998, The Chamberlain Group, Inc. 01-10589D All rights Reserved...