Installation And Accessory Parts - Haier HBC-200 Service Manual

Refrigerator Model:HBC-70/200（India）

INSTALLATION AND ACCESSORY PARTS

Installation and Accessory Parts
Unpacking Your Ice-lined refrigerator
1.Remove all packaging material; this includes the foam base and all adhesive
tape holding the refrigerator accessories inside and outside.
2.Inspect and remove any remains of packing, tape or printed materials before
powering on the refrigerator
Adjusting Your Refrigerator
1.Your refrigerator is designed for freestanding installation only. It should not be
recessed or built-in.
2.Place the refrigerator on a floor strong enough to support it fully loaded.
3.When moving the refrigerator, never tilt it more than a 45-degree angle. This
could damage the compressor and the sealed system.
4.If the refrigerator is tilted let it stand in an upright position for at least 24 hours
prior to plugging. This is to allow the refrigerant to settle.
·Proper Air Circulation
l To assure your refrigerator works at the maximum efficiency it was designed
for, you should install it in a location where there is proper air circulation,
l Plumbing and electrical connections.
l The following are recommended clearances around the refrigerator:
Top. ...............2"(50mm)
Sides..............2"(50mm)
Back..............2"(50mm)
８
PDF created with pdfFactory trial version www.pdffactory.com