Sdi Connection; Component Output; Video Input Setting - JVC SR-HD2500US Instructions Manual

HDMI-CEC
For setting the HDMI-CEC operation from the connected
device.
Setting Values Description
OFF Disables HDMI-CEC.
ON Enables HDMI-CEC.

COMPONENT OUTPUT

For setting the resolution of video output from the
[COMPONENT VIDEO OUT] terminals.
Setting Values Description
480i Sets output to "480i".
480p Sets output to "480p".
720p Sets output to "720p".
1080i Sets output to "1080i".
Memo:
When the resolution is set to "720p", videos are output at
"1080i" other than those recorded at "720p" even though
"720p" is shown on the display.
This unit does not support component output at "1080p". To
output at "1080p", do so via HDMI connection.
If "HDMI VIDEO MODE" is set to "ON", the unit will output
at "480i" regardless of the current setting.
If "HDMI VIDEO MODE" is set to "OFF", or when a HDMI
connection is used, DVD videos will be output at "480p"
even if "720p" or "1080i" has been set.
The aspect ratio of video/S-video output changes according
to the component output setting. As such, there may be
cases where the aspect ratio of the video/S-video output is
different from the predefined setting of the content.

VIDEO INPUT SETTING

Choose a setting according to the video terminal to be
connected when an external analog input terminal is used.
Setting
Values
VIDEO Use this setting when connecting via the
video (BNC) terminal.
S-VIDEO Use this setting when connecting via the
S-video (black) terminal.
Description

SDI CONNECTION

.
For specifying settings related to the SDI output terminal.
SDI AUDIO INPUT SETTING
Set the channel (Lch, Rch) to which the video/audio of the
SD-SDI/HD-SDI input is to be recorded.
Setting
Values
CH1-CH2 Use this setting to record the digital audio
input by assigning Lch to CH-1 of GROUP1
and Rch to CH-2.
CH3-CH4 Use this setting to record the digital audio
input by assigning Lch to CH-3 of GROUP1
and Rch to CH-4.
CH5-CH6 Use this setting to record the digital audio
input by assigning Lch to CH-5 of GROUP2
and Rch to CH-6.
CH7-CH8 Use this setting to record the digital audio
input by assigning Lch to CH-7 of GROUP2
and Rch to CH-8.
ANALOG Use this setting to record analog audio
signals from the SDI device to the L/Rch.
Memo:
SD-SDI/HD-SDI digital audio (embedded audio) can be
recorded to maximum of four groups, two channel pairs per
each group. (four channels per group)
This unit uses Group 1 and Group 2, and records SD-SDI/
HD-SDI digital audio in the combinations of channels
described below:
GROUP NUMBER
GROUP1
GROUP1
GROUP2
GROUP2
Settings Menu
Description
Lch Rch
CH1 CH2
CH3 CH4
CH5 CH6
CH7 CH8
85