JVC SR-HD2500US Instructions Manual page 24

Preparation
Setting "TIME CODE DISPLAY POSITION"
1 Press the [SET UP] button on the remote control unit
The Settings menu screen appears.
.
2 Press the [ I ] button, and select "SDI
CONNECTION"
The "SDI CONNECTION" screen appears.
.
3 Press the [ J ] or the [ K ] button, select "TIME
CODE DISPLAY POSITION", and press the [OK]
button
.
24
4 Press the [ J ] or the [ K ] button to select the
display position
.
LOWER LEFT : Sets the time code display position to the
bottom left.
: Sets the time code display position to the
LOWER
RIGHT bottom right.
UPPER LEFT : Sets the time code display position to the
top left.
UPPER RIGHT : Sets the time code display position to the
top right.
: Sets the time code display position to the
CENTER
center.
5 Press the [OK] button after making a selection
The time code display position is saved.
Memo:
Setting is now complete. If multiple time code inputs are not
detected from the SDI signals, time code is displayed as
"TC--:--:--:--".
If you have not set a date after selecting "DATE & TIME"
and completing the setting, time code will be displayed as
"--:--:--:--".
Time code is not displayed when the monitor is connected
to the [SDI OUT THROUGH] terminal.