Table of Contents
Advertisement
Chapter 8. Using System Management Services
Use the system management services menus to view information about your system , and to perform
tasks such as setting a password, changing the boot list, and setting the network parameters.
Note: On some of the system management services (or service processor) screens, you will see the term
LPAR, which is equivalent to the term logical partition. This system does not support logical
partitions.
To start the system management services, do the following:
1. For a full system partition, restart the system.
2. Watch the firmware console.
3. Look for the POST indicators memory, keyboard, network, scsi, speaker, which appear across the
bottom of the screen.
Press the numeric 1 key after the word keyboard appears, and before the word speaker appears.
After the system management services starts, the following screen displays:
Main Menu
1
Select Language
2
Change Password Options NOT available in LPAR mode
3
View Error Log
4
Setup Remote IPL (Initial Program Load)
5
Change SCSI Settings
6
Select Console NOT available in LPAR mode
7
Select Boot Options
-------------------------------------------------------------------------------------------
Navigation keys:
-------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
Note: The System Management Services can also be started using the Service Processor Boot Mode
Menu. See page 204.
On all menus except the Main Menu, there are several navigation keys:
M
Return to the main menu.
ESC
Return to the previous menu.
X
Exit the System Management Services and start the operating system.
If X is entered, you are asked to confirm your choice to exit the SMS menus and start the
operating system.
X = eXit System Management Services
229
Advertisement
Table of Contents
