IBM AIX
Checking or changing timeouts
AIX requires the disk settings shown in
Table 4 IBM AIX timeout settings
Setting
PR_key_value
Algorithm
hcheck_interval
hcheck_mode
queue_depth
reserve_policy
rw_timeout
Linux
The following configuration recommendations apply to both RedHat and SuSE.
QLogic Driver parameters (failover enabled):
•
qdepth = 16
•
port_down_retry_count = 30
•
login_retry_count = 30
•
failover = 1
•
load_balancing = 1
•
excludemodel = 0x0
•
auto_restore = 0xA6
QLogic Driver parameters (single path):
•
qdepth = 16
•
port_down_retry_count = 64
•
login_retry_count = 30
•
failover = 1
•
load_balancing = 1
•
excludemodel = 0x0
•
auto_restore = 0xA6
Emulex Driver parameters (single path)
30
Pre-upgrade tasks
Table 4
Value
Description
Sets the key value for persistent reservations. Persistent reservations
NA
are not supported.
Sets the load balancing algorithm to fail_over. All I/O uses a single
fail_over
path. The remaining paths are in standby mode. The value round_robin
is not supported.
60
Sets the path health feature to check each device every 60 seconds.
Specifies the I/O paths monitored by the path health checking feature:
nonactive
nonactive—Checks all I/O paths for Failed status, and checks standby
paths for Used/Opened devices.
8
Sets the queue depth.
Single path
Sets the reserve policy to standard SCSI-2 reservations.
60
Sets the read/write timeout to 60 seconds.
for the native multipath drives.