Kyocera FS-1370DN Operation Manual page 41

>>Unit
? mm
>>X Dimension
Using the Operation Panel
Unit (Selecting the unit of measurement)
1
Press
2
Press
measurement can be selected between millimeters and inches. The
current unit of measurement is displayed (the default setting is mm).
3
Press [OK]. A blinking question mark (?) appears.
4
Select mm or inch using
5
Press [OK].
Set the dimensions of the paper as described in the next section.
Entering the Width and Length
Enter the paper size for X Dimension and Y Dimension as shown in
the figure.
105 to 216mm
(4-1/8 to 8-1/2 inches)
1
When the unit of measurement is set, press
>>X Dimension appears (the paper width setting).
2
Press [OK]. A blinking cursor (_) appears.
216mm
3
Press
the cursor is blinking and display the desired width.
Acceptable paper widths are as follows:
• Cassette: 105 to 216 mm (4.13 to 8.5 inches)
• Paper Feeder PF-100 (optional): 148 to 216 mm (5.83 to 8.5
inches)
4
Display the paper width and press [OK].
5
When the width is set, press
paper length setting). Set the desired length in the same way as the
width.
Acceptable paper lengths are as follows:
• Cassette: 148 to 356 mm (5.83 to 14.02 inches)
• Paper Feeder PF-100 (optional): 210 to 356 mm (8.5 to 14.02
inches)
6
Display the paper length, press [OK].
7
Press [MENU]. The display returns to Ready.
.
or repeatedly until >>Unit appears. The unit of
or .
X Dimension
or to increase or decrease the value of the figure where
. >>Y Dimension appears (the
.
2-23