Cisco PIX 520 - PIX Firewall 520 Installation Manual page 37

Chapter 3 Installing PDM
Step 7 Set the values in the following table:
Field Name
Bits per second
Data bits
Parity
Stop bits
Flow control
Step 8 Click OK to continue.
The HyperTerminal window is now ready to receive information from the PIX Firewall console. Wait
30 seconds for the PIX Firewall startup messages to display. These messages should appear similar to
the following example:
Rebooting....
Cisco Secure PIX Firewall BIOS (4.0) #0: Thu Mar
Platform PIX-515
Flash=i28F640J5 @ 0x300
Use BREAK or ESC to interrupt flash boot.
Use SPACE to begin flash boot immediately.
Reading 1507840 bytes of image from flash.
#############################################################################
64MB RAM
Flash=i28F640J5 @ 0x300
BIOS Flash=AT29C257 @ 0xfffd8000
mcwa i82559 Ethernet at irq 10
mcwa i82559 Ethernet at irq
mcwa i82559 Ethernet at irq 11
-----------------------------------------------------------------------
-----------------------------------------------------------------------
Cisco PIX Firewall Version 6.3
Licensed Features:
Failover:
VPN-DES:
VPN-3DES:
Maximum Interfaces: 6
Cut-through Proxy:
Guards:
URL-filtering:
Inside Hosts:
Throughput:
IKE peers:
Step 9 Press the Enter key if it takes more than a minute for the PIX Firewall command prompt to appear.
If irrelevant characters appear, reset the Bits per second to 9600 and try to connect again.
78-15483-01
Value to Set
9600
8
None
1
Hardware
MAC: 0050.54ff.3772
7 MAC: 0050.54ff.3773
MAC: 00d0.b792.409d
|| ||
|| ||
|||| ||||
..:||||||:..:||||||:..
c i s c o S y s t e m s
Private Internet eXchange
Cisco PIX Firewall
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Unlimited
Unlimited
Unlimited
2 22:59:20 PST 2000
Cisco PIX Device Manager Installation Guide
Installing PDM
3-3