MB260
Analysis origin setup
If you want, you can change the origin of the scanner.
By entering new values for X and Y in mm (X < 209 and
Y < 280), you move the analysed area as shown on the
diagram below.
! 843 - ADVANCED FCT/COPY/ORIGIN
1 Press !, enter 843 using the keypad.
2 Select the X and Y coordinates with the buttons "
or !.
3 Setup the desired coordinates with the numerical
keypad or the buttons " and !.
4 Confirm your choice by pressing the OK button.
5 Quit this menu by pressing the
Contrast setup
The CONTRAST parameter allows to choose the
photocopy contrast.
! 844 - ADVANCED FCT/COPY/CONTRAST
1 Press !, enter 844 using the keypad.
2 Setup the desired level of contrast with the buttons
" and !.
3 Confirm your choice by pressing the OK button.
4 Quit this menu by pressing the
Brightness setup
The BRIGHTNESS parameter allows to lighten or darken
your output.
! 845 - ADVANCED FCT/COPY/BRIGHTNESS
1 Press !, enter 845 using the keypad.
2 Setup the desired brightness with the buttons "
and !.
3 Confirm your choice by pressing the OK button.
4 Quit this menu by pressing the
Paper type setup
! 851 - ADVANCED FCT/SCAN. & PRINT/PAPER
1 Press !, enter 851 using the keypad.
2 Select the paper NORMAL or THICK that you use
with the buttons " and !.
3 Confirm your choice by pressing the OK button.
4 Quit this menu by pressing the
Paper tray selection
The Automatic selection can have two meanings
depending on the paper format defined on the paper
trays. The following table describes the different cases.
Same paper
format in the
trays
Different
paper format
in the trays
! 852 - ADVANCED FCT/SCAN. & PRINT/TRAY
1 Press !, enter 852 using the keypad.
2 Select the default paper tray to use, AUTOMATIC
or MANUAL, with the buttons " and !.
button.
3 Confirm by pressing the OK button.
4 Quit this menu by pressing the
Flat-bed analysis margins setup
If you want to, you can offset the lateral margins of the
document to the left or right during the analysis with your
flat-bed scanner.
1 Press !, enter 854 using the keypad.
button.
2 Setup the left / right margins offsets (by 0.5 mm
steps) with the buttons " and !.
3 Confirm by pressing the OK button.
4 Quit this menu by pressing the
Left and right printing margins setup
If you want to, you can offset the lateral margins of the
document to the left or right during printing.
button.
1 Press !, enter 855 using the keypad.
2 Setup the left / right margins offsets (by 0.5 mm
steps) with the buttons " and !.
3 Confirm by pressing the OK button.
TYPE
4 Quit this menu by pressing the
button.
- 20 -
Default tray
Tray used for copy
Selection between the
AUTOMATIC
main
manual tray.
The
MANUAL
used.
AUTOMATIC The main tray is used.
The
MANUAL
used.
! 854 - ADVANCED FCT/SCAN. & PRINT/
! 855 - ADVANCED FCT/SCAN. & PRINT/
tray
and
the
manual
tray
is
manual
tray
is
PAPER
button.
FLATBED MARG
button.
PRINTER MARG
button.