Lexmark 6500e Setup Manual page 33

IPDS Printer and Host Setup Guide Printer Messages and Problems
PSF/MVS
PSF Startup Proc: Disconnect Interval (DISCINTV)
PSF/2
TCP/IP Settings: Connect Timeout
Tuning Option: Job Interval Shutdown Timer
PSF/AIX
SMIT Printer Def: Connect Timeout
IPDS Timeout = 15 seconds to 10 minutes
If you selected an IPDS Timeout value of 15 seconds to 10 minutes in order to allow the printer IPDS emula-
tion to determine when an IPDS LAN session times out, correct the appropriate host timer/timeout value as
shown below.
PSF/400 with OS/400 V3R1 or V3R6
WRKAFP2: Inactivity Timer (INACTTMR)
PSF/400 with OS/400 V3R2, V3R7, V4R1-R5, V5R1-R4,
V6R1, or greater
CRTPSFCFG: Release Timer (RLSTMR)
PSF/MVS
PSF Startup Proc: Disconnect Interval (DISCINTV)
PSF/2
TCP/IP Settings: Connect Timeout
Tuning Option: Job Interval Shutdown Timer
PSF/AIX
SMIT Printer Def: Connect Timeout
Problem 4: IPDS memory exception
Sometimes an IPDS memory exception is reported to the host.
Solution to Problem
You need to do one or more of the following:
A. Postscript or PCL resources may be saved in the printer memory. The memory cannot be used by IPDS.
Set Resource Save to "Off" in the printer menu to allow permanent downloaded resources from PostScript
and PCL jobs to be deleted. Try reprinting the job after powering the printer OFF and ON.
B. There may be insufficient printer memory to print the IPDS job with print resolution selected in the printer's
MENU/Menus > Option Card Menu > IPDS MENU > EMULATION >IPDS Print Res menu item. Select a
lower print resolution and try reprinting the job.
C. There may be insufficient printer memory to temporarily store IPDS resources and print non-IPDS jobs. Add
more memory to the printer. Requirements vary greatly according to type of printing and types of resources
being used. For information on the minimum recommended installed memory for various printing
4
15 seconds
30 seconds
30 seconds
30 seconds
*NOMAX
*NOMAX
0
0
9999
0
33