Lexmark 6500e Setup Manual page 26

IPDS Printer and Host Setup Guide PSF/2 LAN Printing Using an Internal LAN Print Server
Step 4 Configure the Printer's Print Server TCP/IP Settings
To enable IPDS printing with a Standard Network port or a MarkNet internal LAN print server, several settings
must be verified. You can verify these settings from the printer control panel as shown below.
1 From a Ready state press the MENU button (printers). Touch
2 Use the navigation buttons
3 Select Network/Ports.
TIp: To do this on printers, press the Select button
4 Now you will see a list of menus. Select the Standard Network menu.
5 Select Std Network Setup.
6 Select TCP/IP.
7 Use the navigation buttons or icons to scroll through the options. Check each of the following settings and
change them as needed to configure TCP/IP communication.
TCP/IP Settings
Parameter
Activate
(Printers: Must
cations. MFPs: not displayed.)
IP Address
(Address available from your network administrator)
Netmask
(Appropriate netmask for your network)
Gateway
(IP address of your IP gateway)
Enable DHCP
(On, if you use a DHCP server.)
(Off, if you set the IP address another way.)
Enable RARP
(On, if you use a RARP server.)
(Off, if you set the IP address another way.)
Enable BOOTP
(On, if you use a BOOTP server.)
(Off, if you set the IP address another way.)
Enable AutoIP
(Default is Yes. This is the recommended setting.)
or icon
Value
On
be "On" to enable TCP/IP communi-
157.184.67.102
255.255.255.0
157.184.67.1
On or Off
On or Off
On or Off
Yes or No
or
to scroll to Network/Ports.
; on touch screens touch Network/Ports.
on touch screens.
26