Entering Via Tech Raid Bios Utility - Asus K8V User Manual

4. Connect one end of the second Serial ATA cable to the motherboard's
secondary Serial ATA connector.
5. Connect the other end of Serial ATA cable to the secondary Serial ATA hard
disk.
6. Connect the Serial ATA power cable to the power connector on each drive.
7. Proceed to section 3.4.2 "Entering VIA Tech RAID BIOS Utility" for the next
procedure.

3.4.2 Entering VIA Tech RAID BIOS Utility

1. Boot-up your computer.
2. During POST, press <Tab> to enter VIA RAID configuration utility. The
following menu options will appear.
The RAID BIOS information on the setup screen shown below is for reference
only. What you see on your screen may not exactly match what is shown here.
Create Array
Delete Array
Create/Delete Spare
Select Boot Array
Serial Number View
Channel
Serial_Ch0 Master
Serial_Ch1 Master
On the upper-right side of the screen is the message and legend box. The keys on
the legend box allows you to navigate through the setup menu options. The
message describes the function of each menu item. The following lists the keys
found in the legend box with their corresponding functions.
<F1> :
, :
<Enter> :
<ESC> :
3-8
VIA Tech. RAID BIOS Ver 1.XX
Drive Name Array Name
XXXXXXXXXX
XXXXXXXXXX
View Array/Disk Status
Move to the next item
Confirm the selection
Exit
Create a RAID array with
the hard disk attached to
VIA IDE controller
F1 : View Array/Disk Status
, : Move to next item
Enter: Confirme the selection
ESC : Exit
Mode Size(GB)
xxxxx xxx.xx
xxxxx xxx.xx
Chapter 3: Software support
Status
Hdd
Hdd