Configuring Jmicron Jmb362 Sata Controller - Gigabyte GA-790XT-USB3 User Manual

5-1-2 Configuring JMicron JMB362 SATA Controller

A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. The JMicron JMB362 SATA controller controls the eSATA ports on the back
panel. Then connect the power connector from your power supply to the hard drive.
B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Make sure Onboard ESATA Controller under the Integrated Peripherals menu is enabled (Figure 1). To
create RAID, set Onboard ESATA Mode to RAID.
OnChip IDE Channel
OnChip SATA Controller
OnChip SATA Type
OnChip SATA Port4/5 Type
Onboard USB 3.0 Controller
Onboard ESATA Controller
Onboard ESATA Mode
Onboard LAN Function
Onboard LAN Boot ROM
 SMART LAN
Onboard Audio Function
Onboard 1394 Function
Legacy USB storage detect
Onboard Serial Port 1
OnChip USB Controller
USB EHCI Controller
higf : Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Enabled]
[Enabled]
[RAID]
[As SATA Type]
[Enabled]
[Enabled]
[RAID]
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[Enabled]
[Enabled]
[3F8/IRQ4]
[Enabled]
[Enabled]
F10: Save
Figure 1
- 81 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Appendix