Gigabyte GA-790XT-USB3 User Manual page 82

C. Configuring a RAID array in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to the installation of
Windows operating system for a non-RAID configuration.
After the POST memory test begins and before the operating system boot begins, look for a message which
says "Press <Ctrl-G> to enter RAID Setup Utility" (Figure 2). Press <Ctrl> + <G> to enter the RAID setup util-
ity.
GIGABYTE Technology Corp. PCIE-to SATAII/IDE RAID Controller BIOSv1.06.59
Copyright (C) 2006-2007 GIGABYTE Technology.
HDD0 : ST3120026AS
HDD1 : ST3120026AS
Press <Ctrl-G> to enter RAID Setup Utility ...
In the main screen of the RAID setup utility (Figure 3), use the up or down arrow key to highlight
through choices in the Main Menu block. Highlight the item that you wish to execute and press
<Enter>.
GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOSv1.06.59
[ Main Menu ]
Create RAID Disk Drive
Delete RAID Disk Drive
Revert HDD to Non-RAID
Solve Mirror Conflict
Rebuild Mirror Drive
Save And Exit Setup
Exit Without Saving
[ RAID Disk Drive List ]
[ fg TAB]-Switch Window
Note: In the main screen, you can select a hard drive in the Hard Disk Drive List block and press <Enter> to
see detailed information about the selected hard drive.
Appendix
http://www.gigabyte.com.tw
Figure 2
[ Hard Disk Drive List ]
Model Name
HDD0: ST3120026AS
HDD1: ST3120026AS
[ hi ]-Select ITEM
Figure 3
- 82 -
120 GB Non-RAID
120 GB Non-RAID
Capacity
120 GB
120 GB
[ENTER]-Action
Type/Status
Non-RAID
Non-RAID
[ESC]-Exit