Dram Configuration - Gigabyte GA-790XT-USB3 User Manual

DRAM Configuration

CPU Host Clock Control
x CPU Frequency(MHz)
Set Memory Clock
x Memory Clock
DCTs Mode
DDR3 Timing Items
x CAS# latency
x RAS to CAS R/W Delay
x Row Precharge Time
x Minimum RAS Active Time
x 1T/2T Command Timing
x TwTr Command Delay
x Trfc0 for DIMM1
x Trfc2 for DIMM2
x Trfc1 for DIMM3
x Trfc3 for DIMM4
x Write Recovery Time
x Precharge Time
x Row Cycle Time
higf : Move Enter: Select
F5: Previous Values
x RAS to RAS Delay
** DCTs Drive Strength **
ProcOdt(ohms)
DQS drive Strength
Data drive Strength
MEMCLK drive Strength
Addr/Cmd drive Strength
CS/ODT drive Strength
CKE drive Strength
Bank Interleaving
Channel interleave
higf : Move Enter: Select
F5: Previous Values
CPU Host Clock Control, CPU Frequency (MHz), Set Memory Clock, Memory Clock
The settings under the four items above are synchronous to those under the same items on the MB In-
telligent Tweaker(M.I.T.) main menu.
DCTs Mode
Allows you to set memory control mode.
Ganged
Unganged
DDR3 Timing Items
Manual allows all DDR3 Timing items below to be configurable.
Options are: Auto (default), Manual.
BIOS Setup
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
DRAM Configuration
[Auto]
200
[Auto]
x6.66
[Unganged]
[Auto]
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
DRAM Configuration
Auto
DCT0
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
[Enabled]
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Sets memory control mode to single dual-channel.
Sets memory control mode to two single-channel. (Default)
1333Mhz
SPD Auto
9T 9T
9T 9T
9T 9T
24T 24T
-- --
5T 5T
110ns 110ns
-- --
-- --
-- --
10T 10T
5T 5T
33T 33T
F10: Save
4T 4T
DCT1
60 [Auto] 240
1.0x [Auto] 1.5x
1.0x [Auto] 1.5x
1.25x [Auto] 1.5x
1.5x [Auto] 2.0x
1.5x [Auto] 2.0x
1.5x [Auto] 2.0x
F10: Save
- 40 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults