Asus A8V Deluxe User Manual page 83

Memory Configuration
Memclock Mode
DRAM Over 4G Remapping
Bank Interleaving
Node Interleaving
Burst Length
CAS Latency (CL)
TRC
TRFC
TRCD
TWR
TRWT
TRAS
TRP
TWCL
AsyncLat
Read Preamble Setting
2T Command
Memclock Mode [ Auto]
Allows you to set the memory clock mode. Set by the code using [Auto]
or select [Manual] to set using one of the standard values.
Configuration options: [Auto] [Limit]
DRAM Over 4G Remapping [Disabled]
Enable this item when 4 gigabytes or more DRAM is installed to remap
the memory block just below 4G and move it above 4G.
Configuration options: [Disabled] [Enabled]
Bank Interleaving [Disabled]
Sets whether to allow memory accesses to be spread out over BANKS
on the same node or across nodes, decreasing access contention.
Configuration options: [Auto] [Enabled] [Disabled]
Node Interleaving [Disabled]
Sets whether to allow memory accesses to be spread out over BANKS
on the same node or across nodes, decreasing access contention.
Configuration options: [Auto] [Disabled]
Burst Length [8 Beats]
Sets the burst length in beats. Set to 4 Beats when using 64-bit Dq.
Configuration options: [8 Beats] [4 Beats]
CAS Latency (CL) [Auto]
Sets the CAS Latency. Configuration options: [Auto] [2.0] [3.0] [2.5]
TRC [Auto]
Sets the TRC.
Configuration options: [Auto] [7 CLK] [8 CLK] [9 CLK] [10 CLK]
[11 CLK] [12 CLK] [13 CLK]
ASUS A8V Deluxe motherboard
[Auto]
[Disabled]
[Disabled]
[Disabled]
[8 Beats]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
MEMCLK can be set
by the code using
AUTO, or if you use
LIMIT, you can set
one of the standard
values.
4-17