Table of Contents
Advertisement
8) SATA2345 (SATA 3Gb/s Connectors)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are configured, the total number of hard drives must be an even number.
• A RAID 10 configuration requires four hard drives.
(Note)
When a RAID configuration is built across the SATA 6Gb/s channels, the system performance of
the RAID configuration may vary depends on the devices are connected.
9) SATA01 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and
1.5Gb/s standard. Each SATA connector supports a single SATA device.
7
1
7
1
SATA45
Pin No.
Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
Pin No.
7
1
7
1
SATA01
- 21 -
7
1
7
1
SATA23
DEBUG
PORT
DEBUG
PORT
Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
Hardware Installation
Advertisement
Table of Contents
