NETGEAR WGT624v1 - 108 Mbps Wireless Firewall Router Reference Manual page 30

Reference Manual for the 108 Mbps Wireless Firewall Router WGT624
Now, turn on your computer. If software usually logs you in to your Internet connection,
e.
do not run that software or cancel it if it starts automatically.
Verify the following:
f.
When you turn the router on, the power light
The router's local LAN lights
The router's Internet light
or DSL modem.
Note: For wireless placement and range guidelines, and wireless configuration
instructions, please see
2. Log in to the wireless router.
Note: To connect to the router, your computer needs to be configured to obtain an IP address
automatically via DHCP. If you need instructions on how to do this, please refer to
Appendix C, "Preparing Your
Connect to the router by typing
a.
or Netscape® Navigator.
Figure 3-4: Log in to the router
For security reasons, the router has its own user name and password. When prompted,
b.
enter admin for the router user name and
case letters.
Note: The router user name and password are not the same as any user name or password
you may use to log in to your Internet connection.
3-6
are lit for any computers that are connected to it.
is lit, indicating a link has been established to the cable
Chapter 4, "Wireless
Network.
http://192.168.0.1
password
M-10153-01
goes on.
Configuration."
in the address field of Internet Explorer
for the router password, both in lower
Connecting the Router to the Internet