Asus A7V-E User Manual page 36

3. HARDWARE SETUP
20) ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT:
on the +5-volt standby lead (+5VSB). You may experience difficulty in power-
ing ON your system if your power supply cannot support the load. For Wake-
On-LAN support, your ATX power supply must supply at least 720mA +5VSB.
®
A7V-E
A7V-E ATX Power Connector
21) IDE Activity LED (2-pin IDELED)
This connector supplies power to the cabinet's IDE activity LED. Read and
write activity by devices connected to the Primary/Secondary IDE and Primary/
Secondary ATA100 connectors will cause the LED to light up.
®
A7V-E
A7V-E IDE Activity LED
36
Make sure that your ATX power supply can supply at least 10mA
1 0 1 0
Power Supply On
1 0 1 0
ASUS A7V-E User's Manual
ATX
+3.3Volts +3.3 Volts
-12.0Volts +3.3 Volts
Ground Ground
+5.0 Volts
Ground
Ground
+5.0 Volts
Ground
Ground
Ground
-5.0 Volts Power Good
+5V Standby
+5.0 Volts
+5.0 Volts +12.0Volts
TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.
IDELED