A.1 Regulatory Notices - HTC Mogul Getting Started Manual

A.1 Regulatory Notices
Regulatory Agency Identifications
For regulatory identification purposes, your Mogul is assigned a model
number of TITA100.
FCC ID: NM8TITA100. IC: 4115A-TITA100.
To ensure continued reliable and safe operation of your device, use only the
accessories listed below with your Mogul.
The Battery Pack has been assigned a model number of TRIN160.
This product is intended for use with a certified Class 2 Limited Power
Source, rated 5 Volts DC, maximum 1 Amp power supply unit.
Federal Communications Commission Notice
DECLARATION OF CONFORMITY
UT Starcom hereby declares that this wireless device, Mogul, manufactured
by High Tech Computer Corp., is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
This wireless device, Mogul, manufactured by High Tech Computer Corp.,
complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference
that may cause undesired operation. Responsible Party: High Tech
Computer Corp.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or TV reception, which can be determined by turning the equipment
on and off, the user is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio or television technician
for help.
112 Appendix