Install Microwave Oven - GE PEB2060SMSS - Countertop Microwave Oven Installation Instructions

❒
3
INSTALL ANTI-TIP BRACKET
AND BOTTOM DUCT
A
Disconnect the microwave oven before proceeding with the
installation.
Fasten the anti-tip bracket to the bottom duct by using four
B
round-head screws.
Rear
Round-Head Screws (4)
C Remove any loose items
inside the microwave oven,
including the turntable
and turntable support.
Carefully turn the
microwave upside down.
D
Install bottom duct with
four round-head screws
as shown.
❒
4
INSTALL SIDE DUCT AND
UPPER DUCT
A Connect the side duct to the upper duct as shown.
1. Insert projecting tabs of the upper duct into the holes
of the side duct.
2. Bend the tabs up with caution as shown.
NOTE: Remove any oil or dirt on the surface of the
microwave oven before the ducts are attached.
Upper Duct
3 Tabs
3 Holes
(1)
Side Duct
Installation Instructions
Front
Round-Head Screws
Microwave Oven Upside Down
(2)
❒
4
INSTALL SIDE DUCT AND
UPPER DUCT
B Set the microwave upright, being careful not to bend the
front flange. Remove the one existing screw from the left
side of the microwave oven.
C As indicated on the supplied template (publication
#31-41003), fold or cut along the "cut lines" and place the
template on top of the microwave oven. By aligning the
template with the outside edges of the oven, you will see
exactly where to place the upper duct assembly. Peel off the
backing from the double-sided tape. Carefully position the
side duct and upper duct assembly on the microwave
cabinet, aligning with the bottom screw hole. Press down
firmly on the ducts. Fasten the duct assembly to the left
side of the cabinet with the screw removed above.
❒
5

INSTALL MICROWAVE OVEN

INTO CABINET
A Slide the microwave oven part way into the cabinet opening.
Bottom Duct
Anti-Tip
Brace
B Plug in the microwave oven.
The anti-tip bracket must be flat to the cutout floor to engage
C
correctly with the anti-tip brace as shown. Carefully slide the
microwave back, making sure the power cord is not mashed or cut.
Center the microwave oven within the cutout opening and
D
slide the microwave oven in place, engaging the anti-tip brace.
E
Ensure the microwave oven is accurately centered.
3
(cont.)
Existing Screw (1)
Anti-Tip Assembly
Round-Head
Screw
Anti-Tip Bracket