◆ NOTE:
• Input a reference signal when mixing SDI input audio.
• IEEE1394 input audio cannot be used for voice-overs.
Voice-Over From Still Image Status
1
2
1
Open the play list screen.
2
Use the cursor buttons to select the event where you
want to perform a voice-over.
Voice-Over From Playback Status
1
2
1
Open the play list screen.
96
Using Play List: Simplified Voice-Over
3
Find the location for the voice-over.
6
4
Use the operation buttons or the search dial to find a
location for a voice-over and press STILL
4
Press the A.DUB button.
This generates an A DUB PAUSE state while a still image
is output at the still location.
5
Press the STILL
Press the STILL
reverse and a 2-second playback interval, sound
recording starts.
Use the VR (audio volume) controls as necessary to adjust
the playback sound level.
3,5
6
Press the STOP
◆ NOTE:
• When the 24PN play list format is set in setup menu No. 026
2
Use the cursor buttons to select the event where you
5
4
want to perform a voice-over.
3
Press the PLAY
location before the voice-over.
4
Hold down the A.DUB button and press the PLAY
button at the voice-over location.
This starts the audio recording.
Use the VR (audio volume) controls as necessary to adjust
the playback sound level.
5
Press STOP
◆ NOTE:
3
• When the 24PN play list format is set in setup menu No. 026
button.
button again. After a 2-second auto
button to end the voice-over.
(PLY LST FMT), the audio IN and OUT points are set in 4-frame
increments. If the recording starts or stops at some other points,
the IN and OUT points are automatically corrected within the
recording range.
button to start playback at a
button to end the voice-over.
(PLY LST FMT), the audio IN and OUT points are set in 4-frame
increments. If the recording starts or stops at some other points,
the IN and OUT points are automatically corrected to fall within
the recording range.
.