Table of Contents
Advertisement
Item
FR
SUPER
No.
DISP.
518
VITC GEN
519
UB OUT SEL
Definition of terms:
SBC (Sub Code Data) area:
VAUX (Video Auxiliary Data) area:
VIDEO
This menu is used for video settings.
Item
FR
SUPER
No.
DISP.
601
VIDEO INT SG
602
SDI IN MODE
130
Setup: Item Settings
Setting
FR
SUPER
No.
DISP.
0000
OFF
59.94Hz
0001
ON
Specifies whether or not the internal time code generator value should be recorded in the
VAUX area.
0: The internal time code generator value is not recorded.
Record the time code value when it is superimposed on input video signals.
1: The internal time code generator value is recorded.
NOTE:
• When 1394 is selected as the input signal, the time code signal superimposed on the
compressed input signal is recorded regardless of settings in this menu.
• When 23.98, 24, 29.97, 59-23, 60-24, 25, 60-25 is selected in menu No. 25 SYSTEM
FREQ, the internal time code generator value is recorded as the time code in the
VAUX area.
0000
SBC
59.94Hz
0001
F_RATE
Selects user bits in the LTC data output by the TIME CODE OUT and HD SDI connectors
or user bits in the SBC area (DVCPRO HD only) output via the IEEE 1394 terminal during
playback of clips in 720/24PN, 720/30PN and 720/25PN formats as well as optional AVC-
Intra 1080/24PN, 30PN and 25PN clip formats.
0: Outputs the user bits recorded in the SBC area.
1: Outputs the frame rate information recorded in the VAVX area.
This area, which is separate from video and audio data area on a P2 card, stores SMPTE/
EBU compliant time code, recording dates and other information.
An area in the video data on a P2 card that stores additional information on video data.
Setting
FR
SUPER
No.
DISP.
0000
100%CB
Sets the internal signal type. SMPTE and ARIB signals are available in HD mode only
(black in SD mode).
0001
75%CB
0: 100% color bar
0002
SMPTE
1: 75% color bar
0003
ARIB
2: SMPTE color bar
0004
BLACK
3: ARIB color bar
4: Black
0000
DR OFF
59.94Hz
0001
DR ON
60-25Hz
Specifies the method for processing HD SDI input. (Available only for DVCPRO HD)
0: Records the 8 higher bits after rounding up the two lowest bits.
1: Records the signal with 8 higher bits, obtained by dynamic rounding.
NOTE:
Records 8 high-order bit signals after rounding off the 2 low-order bits during SD SDI
input.
Settings and brief function description
50Hz
only
only
50Hz
* An underlined setting indicates an initial value.
Settings and brief function description
50Hz
29.97Hz
59-23Hz
only
60-24Hz
25Hz
Advertisement
Table of Contents
