LG WM2277HS Owner's Manual page 6

INSTALLATIONINSTRUCTIONS
= installation clearances
The location must be large enough to fully open
the washer door
•' Washer dimensions
• Most installations require a mimmum 4 in.
(10 cm) clearance behind the washer.
= Minimum installation spacing for
recessed area installation.
The following dimensions shown are for the minimum
spacing allowed
Additional spacing should be considered for
installation and servicing
• Additional clearances might be required for wall,
door and floor moldings.
-Additional spacing of 1 in (2 5 cm) on all sides of
the washer is recommended to reduce noise
transfer.
Companion appliance spacing should also be
considered
(75 6cm) (10cm)
[Side vi_]
::_ i:)i!: •
"=i _ _ _ :::
!" -_b-b-- =T' -_F+_- I"
(2 5cm) (686 cm) (25 cm)
iFront view]
= Level floor
• Allowable slope under entire washer is 1°.,
. To mlnlmtze noise and vibration, the washer
MUST be Installed on a solidly constructed
floor.
. Carpeting and soft tile surfaces are not
recommended
• Never install the washer on a platform or weakly
supported structure
NOTE: A lirm, solid floor is even more crilical to a
front Joading _vasher than Io a top-loader.
If your floor is wo(_l aml!or frame
conslrnclion, y_m may need to reinforce iL
Front-loaders use substantially fas|er spin
speeds than top-loaders, causing greater
vibration, If the floor is md solid, your washer
will vibrate. Yon will hear and feel the
vibration lhroaghoul your Imuse.
•' Power outlet
• Must be within 60 in (1 5 m) of either side of the
washer, Do not overload the cutlet with more
than one appliance
• Time-delay fuseor circuit breaker is recommended
NOTE: It is the personal responsibility and obligation
of the customer to have a proper outtel
installed by a qualified eleelrician.
6