eMachines W3650 Reference Manual page 53

www.emachines.com
7
Remove the seven system board screws. (The illustration
below is a typical system board, and your system board
may be different.)
8
Lift the system board up and out of the case.
9
Align the new system board on the screw holes in the
case, then secure it into the case with the screws.
10
If your replacement system board does not include a
processor, remove the processor and heat sink assembly
from the old system board by following the directions in
"Replacing the heat sink and processor" on page
then install them into the new system board by following
the directions in the same procedure.
11
Slide the power supply back into the case, then install the
four screws to secure the power supply to the case.
12
Connect all power and data cables using your notes from
Step 5.
13
Reinstall any memory you removed previously.
14
Reinstall any expansion cards you removed previously.
15
Replace the side panel by following the instructions in
"Replacing the side panel" on page
Screws
Screws
33.
40,
47