Subsystem Submenu - BBE DS24 User And Reference Manual

Press MENU, NEXT and ENTER. Then use the NEXT/BACK and ENTER buttons to adjust the
Security Submenu.
The various locking modes are as follows:
1.LOCK: Changes only: Parameters can be viewed, but cannot be adjusted. MUTE buttons
are valid.
2.LOCK: Changes + View: Parameters cannot be viewed or adjusted. MUTE buttons are
valid.
3.LOCK: Changes + Mutes: Parameters can be viewed, but cannot be adjusted. MUTE but-
tons are not valid.
4.LOCK: Everything: Parameters cannot be viewed or adjusted. MUTE buttons are not
valid.
Once a security mode is selected, press ENTER. You will be prompted to enter a security
code. This can be from one to four characters. Any of the characters available from the
on-board selection choices may be used.
A.Press the BACK/NEXT buttons to shift the cursor to one of the four positions. Then
rotate the PARAM dial to select the desired character (letter, number or symbol).
B.Press ENTER, confirm the password and display as follows:
C.Repeat procedure A and press ENTER.
D.The system is locked when the reentered password matches the original entry
otherwise the locking operation is invalid. If invalid, the screen will show "Locks Not
Set!! Bad Confirmation". If the codes match, the screen will show "Locking Unit".
Though up to four characters may be used, the lock out will work with just a single
character. The initial and confirming entry must both be in the same position. If noth-
ing is entered (all blanks) the unit will still lock.

7.4 Subsystem Submenu

This menu allows selection of Input Linking; a "wake up time" fade in or Mute Hold; and
the method for displaying delay: Time, Meters or Feet.
Press MENU, NEXT and NEXT again. Then use the BACK/NEXT and ENTER buttons to
adjust the Subsystem Submenu. Subsystem Submenu items are as follows:
1.Input option: Determines whether the A and B inputs are linked or separate.
2.Wake up time:
OPERATION
9