Brother HL 5370DW - B/W Laser Printer Quick Setup Manual page 35

Wireless Network
k
The wizard will search for wireless networks
available from your printer. Choose the access
point you wish to associate the printer with, and
then click Next.
Note
• "SETUP" is the default SSID of the printer. Do
not choose this SSID.
• If the list is blank, check that the access point
has power and is broadcasting the SSID, and
then see if the printer and the access point are
within range for wireless communication. Then,
click Refresh.
• If your access point is set to not broadcast the
SSID you can manually add it by clicking the
Add button. Follow the on-screen instructions
for entering the Name (SSID), and then click
Next.
l
If your network is not configured for
Authentication and Encryption, the following
screen will appear. To continue configuration,
click OK and go to n.
m
If your network is configured for Authentication
and Encryption, the following screen will
appear. When configuring your Brother
wireless printer, you must configure your
printer to match the Authentication and
Encryption settings you wrote down on
page 33 for your existing wireless network.
Choose the Authentication Method and
Encryption Mode from the pull-down menu in
each setting box. Then enter the Network Key
and Confirm Network Key, and then click
Next.
Note
• If you want to setup or configure additional
WEP key indexes other than WEP key1, click
Advanced.
• If you do not know the Authentication or
Encryption settings for your network, contact
your network administrator or the manufacture
of your access point/router.
• If you are using WEP and the printed Network
Configuration page in n shows Link OK in the
Wireless Link Status, but the printer is not
found, make sure you entered the WEP key
correctly. The WEP key is case sensitive.
Macintosh
35