Table of Contents
Advertisement
Three additional stations may be preset on each band by
pressing two adjoining buttons at the same time.
1. Tune in the desired station.
2. Press the SET pushbutton. (SET appears in the
3. Within five seconds, push any two adjoining
display.)
pushbuttons at the same time. The station will return
when the same two buttons are pressed again.
Setting the Tone
BASS: Slide the bass lever up to increas,e the bass
response. Adjust the bass lever to give a pleasing sound
to your ear.
TREBLE: Slide the treble lever up to increase the treble
response. If the station is weak or noisy, slide the treble
lever down to reduce the noise.
Adjusting the Speakers
BAL: The BAL control behind the upper knob allows
you to balance the sound between the right and left
speakers.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on each side. Tapes longer than
that
are so
thin that they may not work well in this
player.
Once the tape is playing, use the upper and lower knobs
for volume, balance and fade just as you do for the
radio. The lighted arrow shows which side of the tape is
being played.
FORWARD: To advance the tape, press the arrow
button in the direction the tape is playing and the tape
will advance rapidly until you press the STOP-EJECT
button lightly.
REVERSE: To reverse the tape, press the arrow button
in the opposite direction the tape is playing and the tape
will reverse rapidly until you press the STOP-EJECT
button lightly.
PROG-RCL: To go from one side
of
the tape to the
other, press this knob.
STOP-E JECE To remove the tape or stop the tape and
change to radio, press the STOP-EJECT button.
FADE: The control behind the lower knob moves the
sound between your front and rear speakers.
Advertisement
Table of Contents
