Table of Contents
Advertisement
For a single wiping cycle, turn the band
to MIST. Hold
Windshield Washer
it there until the wipers start, then let go. The wipers will
stop after one cycle. If you want more cycles, hold the
band on MIST longer.
At the top of the turn signal/multifunction lever, there's
a paddle with the word PUSH on it. To spray washer
fluid on the windshield, push the paddle for less than
For steady wiping at low speed, turn the band away
from you to the LO position. For high-speed wiping,
turn the band further, to
HI.
To
stop the wipers, move
the band to OFF.
The wiper speed may be set for a long or short delay
between wipes. This can be very useful in light rain or
snow. Turn the band to choose the delay time. The
closer to LO, the shorter the delay.
Heavy snow or ice can overload your wiper motor. A
circuit breaker will stop the motor until it cools. Clear
away snow or ice to prevent an overload.
Keep in mind that damaged wiper blades may prevent
you from seeing well enough to drive safely. To avoid
damage, be sure to clear ice and snow from the wiper
blades before using them. If your blades do become
damaged, get new blades or blade inserts.
second. The wipers will clear the window and either
stop or return to your preset speed. For more washer
cycles, push and hold the paddle.
on't use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking
2-37
Advertisement
Table of Contents
