Table of Contents
Advertisement
iDect_V2_IFU_master.book Page 38 Friday, April 4, 2008 4:05 PM
Troubleshooting
"My call was cut
Move the handset closer to the base unit before you try
off when I went
again to make a call.
out of range. Now
I can't use my
handset."
"I hear 'beeps'
You may be going out of range of the base unit. Move
from my handset
closer, or your call may be cut off.
while I'm on a
Check the 'battery charge level' symbol on the display.
call."
If it is low, recharge the batteries.
"The Caller
You need to subscribe to the Caller Display feature.
Display feature
Contact your service provider (BT or cable company).
isn't working."
The caller may have withheld their number by dialling
141. Or they may be calling from a network that does not
transmit the Caller ID (for example, it may be an
international call).
"When I try to
If you have more than one handset registered to your
make a call, I hear
base unit, make sure that another handset isn't already
Busy tone."
using the line.
"The volume in
Make sure you're holding the earpiece correctly over
the earpiece is
your ear.
low when I'm on a
Adjust the volume using the
call."
Using a multi-handset system
"I can't transfer a
Make sure the other handset is in range of the base unit.
call."
Make sure you're dialling the correct number for the
other handset (1 to 4).
38
U
D
or
button.
Advertisement
Table of Contents
