Dometic CA1000 Installation Manual page 32

_IA_CA1000.book Seite 32 Freitag, 30. Januar 2009 11:12 11
Installation
7.3.3 Menu level 2: Switching from AC to AC/DC operation
You can upgrade the roof air conditioner with the CA-DC kit so that it can
not only be used with the vehicle stationary, but also while driving. To do
this, you must reconfigure the system software. No alterations need to be
made in this menu when you operate the system without a CA-DC up-
grade kit.
➤ Start configuration mode (see chapter "Start and end configuration
mode" on page 31).
✓ The first digit of the display (fig. e 5, page 6) shows the menu level
and the second and third show the parameter which can be set.
➤ Press the + button (fig. e 6, page 6) once to switch to menu level 2.
➤ Press the Mode button (fig. e 4, page 6) to change the parameter.
✓ The digits in the display flash until the parameter you enter is con-
firmed.
➤ Press the + and – buttons (fig. e 6 und 7, page 6) to select AC mode
(
➤ Press the Mode button (fig. e 4, page 6) to confirm your entry.
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 2 and can use the + and – buttons to switch
between menu levels.
7.3.4 Menu level 3: Operating mode
The system always starts with a defined operating mode for room temper-
ature. This parameter can be configured:
➤ Start configuration mode (see chapter "Start and end configuration
mode" on page 31).
✓ The first digit of the display (fig. e 5, page 6) shows the menu level
and the second and third show the parameter which can be set.
➤ Press the + button (fig. e 6, page 6) twice to switch to menu level 3.
➤ Press the Mode button (fig. e 4, page 6) to change the parameter.
✓ The digits in the display flash until the parameter you enter is con-
firmed.
➤ Use the + and – buttons (fig. e 6 and 7, page 6) to select the mode
the system starts in (e.g.
➤ Press the Mode button (fig. e 4, page 6) to confirm your entry.
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 3 and can use the + and – buttons to switch
between menu levels.
32
) or AC/DC mode (
01 02
).
for automatic mode or
00
Dometic CA1000
for mode 1 etc.).
01