Cutting Titles - Ulead DVD WORKSHOP 2 User Manual

Cutting titles

You can split a single video clip into two separate titles with different starting and
ending points. The mark-in and mark-out points of each new title is determined by
the position of the Jog Bar in the Navigation Panel.
Refer to the example below for the process of cutting titles. We have labeled the
original mark-in of the title as point A, its mark-out point as point B, and the Jog
Bar position as point C.
Using the Jog Bar, go to the frame where you want to split your title then click Cut
Title in the Options Panel.
Two new titles with different mark-in and mark-out points are displayed in the
Title List.
Check the mark-in and mark-out fields in the Options Panel. You will see that the
mark-in of the first new title is A and its mark-out C, while the mark-in of the
second new title is C, and its mark-out is B.
You can split these two new titles further by selecting one, moving the Jog Bar to
another position, and repeating the whole process.
Note: Cut Title is only applicable to video clips. Displayed above are the mark-in
and mark-out times of the first (left) and second new title (right). Notice that the
mark-out time on the left is the same as the mark-in time on the right.
ULEAD DVD WORKSHOP USER GUIDE 65