Frusdr Load Utility Command-Line Options - Intel SR870BN4 - Server Platform - 0 MB RAM Product Manual

NOTE
The user can run the utility directly from the configuration software CD-
ROM or from diskettes the user creates from the CD-ROM included in the
Country Kit shipped with the system. If the user chooses to run the
FRUSDR Load Utility from a diskette, the user must copy the utility from
the CD-ROM and follow the instructions in the included README.TXT
file.
5. Use the FRUSDR Load Utility to manage the server management subsystem's product level
FRU and SDR repository.
6. Reboot the system by powering off and powering on the server. The reboot operation is
necessary because the firmware must reload to properly initialize the sensors after
programming and thus effect the changes the user has made to the FRU and SDR repository.

FRUSDR Load Utility Command-line Options

The basic command line format is:
frusdr [/?] [/h] [/p] [/d { fru, sdr}] [/Cfg filename.cfg]
Where:
/? or /H
/D SDR
/D FRU (Address)
/CFG (filename.cfg)
/P
The /D FRU option displays FRU information from a device at the specified address allowing any
FRU to be displayed. The parameters following the /D FRU are the same values as the FRU file
header addresses, namely: NVS_TYPE, DEVICE_ID, DEV_CNTR (aka Device Controller),
NVS_LUN, DEV_BUS and DEV_ADDRESS.
Intel® SR870BN4 Server System Product Guide
Displays usage information
Displays the sensor data records
Displays the FRU located at a given address
Uses the specified custom configuration file
Pause the display between blocks of data to prevent the displayed data from scrolling
off the screen
75