IBM 8670 - Eserver xSeries 345 Installation Manual page 16

Table 1. Features and specifications
Microprocessor:
®
™
v Intel Xeon , 3.067 GHz or higher
depending on server model
v 533 MHz front-side bus (FSB)
v Support for up to two
microprocessors with Intel
Hyper-Threading technology
Memory:
v Minimum: 512 MB, expandable to 8
GB
v Type: PC2100 (CL2.5), downward
compatible with PC1600 (CL2),
registered, ECC, double data rate
(DDR), SDRAM
v Sizes: 256 MB, 512 MB, 1 GB, or
2 GB, in pairs
v Connectors: Two-way interleaved,
four dual inline memory module
(DIMM) connectors
v Maximum: Two pairs of DIMMs
Drives:
v Diskette: 1.44 MB
v CD-ROM: IDE
Expansion bays:
v Six hot-swap, slim-high, 3.5-inch
drive bays (hot-swap hard disk
drives installed, some models)
v One 5.25-inch bay (CD-ROM drive
installed)
v One 3.5-inch removable-media
drive bay (diskette drive installed)
Expansion slots:
v Two PCI-X non-hot-plug 133
MHz/64-bit
v Two PCI-X non-hot-plug 100
MHz/64-bit (low profile)
v One PCI non-hot-plug, 33
MHz/32-bit
Hot-swap fans:
Standard: Eight - provide redundant
cooling
4
IBM xSeries 345 Type 8670: Installation Guide
Hot-swap power supplies:
514 watts (115-230 V ac)
v Minimum: One
v Maximum: Two - provide
redundant power
Size (2 U):
v Height: 85.4 mm (3.36 in.)
v Depth: 698 mm (27.48 in.)
v Width: 443.6 mm (17.5 in.)
v Weight: approximately 21.09 kg
(46.5 lb) to 28.12 kg (62 lb)
depending upon configuration
Integrated functions:
v IBM integrated system
management processor (ISMP)
– Service processor with Light
™
Path Diagnostics
– Interconnect port
– Dedicated I/O port
– Support for IBM Remote
Supervisor Adapter
v Two 10BASE-T/100BASE-
TX/1000BASE-T Ethernet ports
(Intel Ethernet controller on
system board)
v One serial port
v One external and one internal
Ultra320 SCSI port (dual-channel
integrated controller with RAID
capabilities)
v Three Universal Serial Bus (USB)
v1.1 ports
v Keyboard port
v Mouse port
v ATI Rage XL video (controller on
system board)
– Compatible with SVGA and
VGA
– 8 MB video memory
Environment:
v Air temperature:
– Server on: 10° to 35°C (50.0°
to 95.0°F); altitude: 0 to 2133
m (6998.0 ft)
– Server off: 10° to 43°C (50.0°
to 109.4°F); maximum altitude:
2133 m (6998.0 ft)
v Humidity:
– Server on: 8% to 80%
– Server off: 8% to 80%
Acoustical noise emissions:
v Declared sound power, idle: 6.5 bel
v Declared sound power, operating:
6.5 bel
Heat output:
Approximate heat output in British
thermal units (Btu) per hour:
v Minimum configuration: 341 Btu (100
watts)
v Maximum configuration: 2250 Btu
(660 watts)
Electrical input:
v Sine-wave input (50-60 Hz) required
v Input voltage range automatically
selected
v Input voltage low range:
– Minimum: 90 V ac
– Maximum: 137 V ac
v Input voltage high range:
– Minimum: 180 V ac
– Maximum: 265 V ac
v Input kilovolt-amperes (kVA)
approximately:
– Minimum: 0.1 kVA
– Maximum: 0.7 kVA
Notes:
1. Power consumption and heat
output vary depending on the
number and type of optional
features installed and the
power-management optional
features in use.
2. These levels were measured in
controlled acoustical environments
according to the procedures
specified by the American National
Standards Institute (ANSI) S12.10
and ISO 7779 and are reported in
accordance with ISO 9296. Actual
sound-pressure levels in a given
location might exceed the average
values stated because of room
reflections and other nearby noise
sources. The declared sound-power
levels indicate an upper limit, below
which a large number of computers
will operate.