11. Connect the new fan's cable to the connector on the fan module.
12. Insert the top of a new fan into the fan module and rotate the bottom in until tab (B) locks it
in place.
13. Align the holes in the fan module with the raised tabs on the chassis and lower the fan module
onto the chassis floor.
14. Slide the fan module toward the chassis sidewall until it has locked in place.
15. Plug the fan cables into the server board system fan connectors.
16. Make sure the USB cable is routed along the top of the fan module.
17. Connect the flex circuit cable to the backplane.
18. Install the flex circuit cable retention clip.
19. Install the full-height PCI riser card.
20. Replace the chassis cover.
Working Inside Your Server
A
C
B
Figure 39. Installing the New Fan
OM14613
57