Starting A Data Collection; Using The Keep Option - Texas Instruments TINSPIRE Manual Book

Teacher software guidebook

Hide thumbs Also See for TINSPIRE:

Table of Contents

Starting a data collection

Use this method to start a collection. If you already have a collection you

must decide if you want to overwrite the existing data or store it.

If you do not need to save the data from the previous run, you can

overwrite the data set by performing the following step.

If you want to store your existing data set and not overwrite the data,

see Storing data before performing this step.

Start the Data Collection by selecting

If in Meter View, the Vernier DataQuest™ application changes to

Graph View and the recording of sensor data is enabled. The graph is

updated to show the collected data as it is occurring.

Events, data points are not recorded until you select

See Using the Keep option.

Use the Keep option to store the connected sensor's values.

Note: See Setting and using a collection mode to assign the entry name

and unit labels.

Using Keep stores a specific data point. This option is available when the

Collection Mode specified is "Events with Entry" or "Selected Events."

If the Collection Mode is "Events with Entry," you must assign the

independent value that corresponds to the dependent variable.

Data Collection and Analysis

When using data modes Events with Entry or Selected

Experiment > Start Collection

Experiment >