Indication For Flash Memory; Indication For Ipod Mode; Bluetooth Mode - Alpine CDE-133BT Owner's Manual

• Mechanism error.
1 Press the  button and eject the CD.
If not ejecting, consult your Alpine dealer.
2 When the error indication remains after ejecting, press the 
button again.
If the error indication still does not turn off after pressing the 
button for a few times, consult your Alpine dealer.
• When "ERROR" is displayed:
If the disc cannot be ejected by pressing , press the RESET button
(refer to "Initial System Start-Up" on page 8) and press  again.
If the disc still cannot be ejected, consult your Alpine dealer.
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.

Indication for Flash Memory

• A USB device that is not supported by the unit is connected.
– Connect a USB device that is supported by the unit.
NO DEVICE
• A Flash Memory is not connected.
– Make sure the Flash Memory device is correctly connected and the
cable is not excessively bent.
• No MP3 (file) is stored in the Flash Memory.
– Connect the Flash Memory device after storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.
NO SUPPORT
• Text information that is not recognizable by the unit has been input.
– Use a Flash Memory device with input text information that is
supported by the unit.
• Communication error.
– Turn the ignition key off, and then set to ON again.
– Check the display by reconnecting between the Flash Memory and
this unit.
• Power surge error.
Excessive voltage/current is supplied to the Flash Memory.
– Try another Flash Memory, if available.

Indication for iPod Mode

• The iPod/iPhone is not connected.
– Make sure the iPod/iPhone is correctly connected (refer to
"Connections" on page 35).
Make sure the cable is not bent excessively.
• There are no songs in the iPod/iPhone.
– Download songs to the iPod/iPhone and connect to this unit.
• Communication error.
– Turn the ignition key off, and then set to ON again.
– Reset the iPod.
– Check the display by reconnecting between the iPod/iPhone and
this unit, using the iPod/iPhone cable.
• Caused by the iPod/iPhone Software Version not being compatible
with this unit.
– Update the iPod/iPhone Software Version to be compatible with
this unit.
• The iPod/iPhone is not verified.
– Reset the iPod.
– Try another iPod/iPhone, if available.
• Power surge error.
Excessive voltage/current is supplied to the iPod/iPhone.
– Try another iPod/iPhone, if available.

BLUETOOTH mode

• The BLUETOOTH device is not connected.
– Connect the BLUETOOTH device.
31
-EN