GMC JIMMY 2002 Manual page 146

Training a Garage Door Opener with
Rolling Codes (If Equipped)
If you have not previously programmed the hand
transmitter to HomeLink, see "Programming the
HomeLink Transmitter" listed previously. If you have
completed this programming already, you now need to
train the garage door opener motor head unit to
recognize HomeLink.
1. Find the "Learn" or "Smart" button on the garage
door opener motor head unit. The exact location and
color will vary by garage door opener brand. If you
have difficulty finding the Learn or Smart button,
refer to your garage door opener owner's manual or
contact the manufacturer of HomeLink at
- - -
1 800 355 3515, or on the internet at
www.homelink.com.
2. Because of the steps involved, it may be helpful to
have another person assist in programming the
transmitter.
2-80
3. Press the "Learn" or "Smart" button on the garage
door opener motor head unit. An indicator light will
begin to flash when the motor head unit enters the
-
held
training mode.
Following this step, you have 30 seconds to
start Step 3.
4. Return to HomeLink in your vehicle and firmly press
and release the programmed HomeLink button
three times.
-
The rolling code garage door opener should now
recognize HomeLink. You may either use HomeLink or
-
the hand held transmitter to open the garage door.
If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1
the internet at www.homelink.com.
- - -
800 355 3515, or on