Assigning The Component Video Inputs - Pioneer Elite VSX-49TXi Operating Instructions Manual

Advanced Setup

Assigning the Component Video Inputs

If you used component video cords (and only if you did so) to connect any equipment you must tell the
receiver which device is hooked up with this special kind of cable. If you did not use component video
cord (which is a specialized cord that separates the video signal into two color spectrums and a light
spectrum for transmission) then you don't need to worry about the procedure below. The default settings
for the component video inputs are as follows: 1= DVD; 2= off; 3= off.
1
Receiver
RECEIVER
TONE
DVD/LD
VCR1
DISPLAY
/DVR
DIMMER
VCR2
STATUS
VCR3
3
SYSTEM
TV
SETUP
4
System Setup
[ Auto Surround Setup ]
[1. Input Assign
[2. Surround Setup]
[3. Expert Setup]
[4. THX Audio Setup]
[Exit]
5
1.Input Assign
[ 1.Digital-In ]
[ 2.Component Video In
[ 3.i.LINK Input ]
[Return]
6
1.2. Component Video In
Component-1
Component-2 [ OFF
Component-3 [ OFF
7
1.2. Component Video In
Component-1 [DVD/LD ]
Component-2 [
Component-3 [ OFF
memo If you connect the TV monitor with
component video cord, and the DVD
player with composite or S video cord
then you should set that terminal to off.
94
2
MAIN SUB REMOTE
SETUP
BASS/
ATREBLE
CD-R/
TAPE1
EFFECT/
CH SEL.
VIDEO TUNER
SELECT
VIDEO
SPEAKER INPUT
LOUDNESS
A/B ATT.
TAPE 2 SIGNAL
MONITOR SELECT
CONTROL
]
]
[DVD/LD ]
]
]
[Return]
VCR1 ]
]
[Return]
1 Turn on the receiver and your TV,
press the RECEIVER on the remote
control.
CD
2 Press the SUB button on the remote
control.
SAT
TV
3 Press the SYSTEM SETUP button.
4 Looking at the on-screen display on
your TV, use the 5∞ buttons to
select INPUT ASSIGN. Press the
ENTER button.
5 Use the 5∞ buttons to select
C'NENT VIDEO IN. Press the ENTER
button.
6 Use the 5∞ buttons to move
through the different component
video input settings and use the 2 3
buttons to select the component
that you hooked up to that
component video in.
If you're not sure which component is connected to
which component video in, look on the back of the
receiver and check the cables you connected.
7 When you're finished use the 5∞
buttons to select RETURN and press
ENTER.
You will leave the "Assigning the Component Video
Inputs" mode.
8 Use the 5∞ buttons to select
RETURN and press ENTER, again.
Then, use the 5∞ buttons to select
EXIT and press ENTER.