Table of Contents
Advertisement
VideoJet X40
5.
CAUTION!
If older recordings are not allowed to be overwritten when the available memory capacity has
!
been used, the recording in question will be stopped. You can specify limitations for
overwriting old recordings by configuring the retention time (see Section 5.24 Advanced Mode:
Retention Time, page 58).
Formatting Storage Media
You can delete all recordings on a storage medium at any time.
CAUTION!
!
Check the recordings before deleting and back up important sequences on the computer's
hard drive.
1.
2.
3.
4.
Deactivating Storage Media
You can deactivate any storage medium from the Managed storage media list. It is then no
longer used for recordings.
1.
2.
5.22
Advanced Mode: Remote Video Device
You can allow a remote video device to use the VideoJet X40 storage media. This means you
can record video images from a camera that does not have its own storage media, for
example. Once you have entered the IP address of the remote video device and saved it by
pressing Set, the VideoJet X40 is then displayed for selection in the Storage Management for
the remote video device.
Bosch Security Systems
Check the boxes for the Overwrite older recordings option to specify which older
recordings can be overwritten once the available memory capacity has been used.
Recording 1 corresponds to Stream 1, Recording 2 corresponds to Stream 2.
Click a storage medium in the Managed storage media list to select it.
Click the Edit button below the list. A new window will open.
Click the Formatting button to delete all recordings in the storage medium.
Click OK to close the window.
Click a storage medium in the Managed storage media list to select it.
Click the Remove button below the list. The storage medium is deactivated and removed
from the list.
Installation and Operating Manual
Configuration Using a Web Browser | en
DOC | V4.0 | 2009.06
55
Advertisement
Table of Contents
