THUNDER TIGER PHOENIX ST BX Manual page 7

7
ADJUSTING ELECTRIC SPEED CONTROL (ESC)
(Picture shows the Ace R/C "Veloci-RS" electric speed control pre-installing on PHOENIX Ready-To-Run
version). Before operating your model, you have to set to either NEUTRAL, HIGH SPEED and BRAKE
position of the electric speed control prior running the motor.
GREEN / RED
g
j
m
g.
The set-up LED now flashes RED/GREEN to indicate that the ESC is in the set-up mode.
h.
Leave the throttle stick at the neutral position and the throttle trim knob/lever in the middle
i.
Press the set-up button, the neutral setting is now stored, and the set-up LED lightens GREEN.
j.
Move the transmitter stick to full-throttle
k.
Press the set-up button with the stick still in this position
l.
The full-throttle setting is now stored, and the set-up LED lightens RED.
m.
Move the transmitter stick to full brake
n.
Press the set-up button with the stick still in this position.
o.
The brake setting is now stored, and the set-up LED flashes 3 times simultaneously and then goes
RED/GREEN light still.
CONGRATULATIONS!
Your electric speed control is now completely set-up and ready to run.
Remember this! The transmitter is always the FIRST TO BE TURNED ON and THE LAST TURNED
OFF.
If you make a mistake during the set-up procedure, don't worry: disconnect the battery for about 10
seconds and start again from the first step.
Refer to the instruction manual for more information on setting the electric speed control.
h
k
n
GREEN
i
RED
l
GREEN / RED
o