THUNDER TIGER PHOENIX ST BX Manual page 4

1
INSTALLING STEERING SERVO LINKAGE
a
d
a.
Find the appropriate servo horn for your servo. Remove the servo horn from your servo and replace
with the stock horn, then fasten with the stock mounting screw. Install the ball end into the servo horn.
Add the dust cover. Attach the mounts with the screws and washers. Add the spacers if you have an
Airtronics servo.
b.
Mount the servo with two screws.
c.
Assemble the servo link, matching the length to the true scale drawing.
d.
Use needle-nose pliers to attach link to ball ends.
2
INSTALLING THE RADIO GEAR
a
d
a.
Attach speed control to chassis with a piece of double side tape.
b.
Run the wire of the speed control through the battery slot area.
c.
Cut a piece of double side tape, remove the paper from one side, and attach it to the bottom of your
receiver.
d.
Slip the receiver wire through the built-in chassis antenna mount. Remove the paper from the other
side and attach to the chassis as shown.
e.
Plug the small BEC plug into the receiver's on/off switch. Follow the instructions that accompany your
radio receiver system. Use a small zip tie to organize the excess wiring.
b
b
e
(Skip if already assembled)
c
(Skip if already assembled)
c