Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for THUNDER TIGER PHOENIX ST BX
Summary of Contents for THUNDER TIGER PHOENIX ST BX
- Page 1 1:10 ELECTRIC POWERED 2WD TRUCK & BUGGY No.6525-F No.6526-F...
- Page 2 INTRODUCTION Thank you for purchasing the Thunder Tiger PHOENIX stadium truck / buggy. Thunder Tiger strives to bring you the highest level of quality and service we can provide. We race and test our products around the world to bring you state-of-the-art items.
-
Page 3: Items Required For Operation
ITEMS REQUIRED FOR OPERATION For Car Ni-MH Battery Pack 2974 IB Ni-MH Batter Pack, 7.2V/IB3000 2977 IB Ni-MH Batter Pack, 7.2V/IB4200 For Transmitter Power Charger (AC/DC Charger) Nose Plier, 2605AC 110V/7.2-8.4V Philips Screwdriver, 2606AC 230V/7.2-8.4V (2P) Allen Wrench 2607AC 230V/7.2-8.4V (3P) Alkaline Batteries(8), AA-size ITEMS INCLUDED Motor... - Page 4 INSTALLING STEERING SERVO LINKAGE (Skip if already assembled) Find the appropriate servo horn for your servo. Remove the servo horn from your servo and replace with the stock horn, then fasten with the stock mounting screw. Install the ball end into the servo horn. Add the dust cover.
-
Page 5: Preparing The Radio
PREPARING THE RADIO Install the antenna into transmitter. Check the frequency printed on the transmitter crystal. Check the frequency printed on the receiver crystal, and make sure it matches with the transmitter crystal. Make sure no one will operate on the same frequency when you are. When there is a radio glitch, it will most likely be caused by improper crystal, damaged crystal, or people operating on the same frequency. - Page 6 OPERATING RADIO STEERING FUNCTION Check the radio steering functions. With the radio transmitter and receiver on, turn the steering wheel/stick to the left. The front tires/wheels should turn left accordingly. If not, flip the steering servo reverse switch. Return the steering wheel/stick to neutral. The front tires/wheels should point straight forward. If not, use the steering trim lever to correct it.
- Page 7 ADJUSTING ELECTRIC SPEED CONTROL (ESC) (Picture shows the Ace R/C "Veloci-RS" electric speed control pre-installing on PHOENIX Ready-To-Run version). Before operating your model, you have to set to either NEUTRAL, HIGH SPEED and BRAKE position of the electric speed control prior running the motor. GREEN / RED GREEN GREEN / RED...
-
Page 8: Battery Charging
VELOCI SPECIAL FEATURE The VELOCI digital speed controls feature a new overheat protection function. This function protects the VELOCI against overheating during operation. If the speed controls temperature exceeds safe levels, the motor function will be temporarily switched off. However, full steering function is still maintained during this period.