Deck Belt Installation; Deck Belt Removal - Dixon 36 / 968999609 Operator's Manual

Deck belt removal

1. Park on a level surface. Apply parking brake.
2. Lower the deck into the lowest cutting
position.
3. Remove bolts from belt shields and remove
shields.
4. Remove any dirt or grass that may have
accumulated around the cutter housings and
entire deck surface.
5. Carefully roll the belt over the top of the
cutter housing pulleys and remove belt.

Deck belt installation

NOTE: For ease in installing the deck belt, refer to
the routing decal on bottom of seat.
1. Wrap the deck belt around the electric clutch
pulley that is located on the engine shaft.
2. Route the belt forward between the EZT (E-
Series Zeroturn Transaxles) and up onto the
deck.
3. Place belt around spring loaded idler pulley.
4. Wrap the belt around the stationary idler
pulley and around the mandrel housings.
5. Push inward on the idler arm and carefully
route belt over stationary idler pulley. Once
belt is properly routed, slowly release idler
arm to tension belt.
6. Double check belt routing to make sure it
matches the routing decal, and the belt does
not have any twist. Correct as needed.
7. Adjust tension with deck eyebolt.
8. Replace belt shields on both mandrel
housings and secure with fasteners.
42
-
English
MAINTENANCE
2
1. Shield bolts
2. Belt shields
Removing deck belt
1. Clutch pulley
2. Deck belt
Belt routing, deck belt
1
1
2
8050-773
8050-773