Denon POA-3012CI - Multi-Zone Audio Distribution Power Amplifier Control Protocol page 7

COMMAND and PARAMETER list
COMMAND CHANNEL
PW 00
SV *01-12
SO 02-12(EVEN)
SF *01-12
SI *01-12
ST 02-12(EVEN)
00
SV COMMAND : "*" parameter uses two or three ASCII characters. (see page6 D) section)
*01-12 : The ZONE that "Normal mode" was selected, odd and even CHANNEL selectable. If the ZONE that "BRIDGED mode" was
selected, only an even number CHANNEL selectable.
PARAMETER
ON POWER ON/STANDBY change
STANDBY
? Return PW Status
UP CHANNEL VOLUME UP/DOWN , direct change to **dB SV01UP<CR>
DOWN
** **:00 to 99 by ASCII , 90=0dB, 99=---(MIN)
? Return channel volume Status
NOR Operation mode NORMAL/BRIDGED change
BRI
? Return operation mode status
OFF Channel Low Cut Filter OFF/ON change
ON
? Return channel Low Cut Filter status
BUSL Select input "BUS L"
BUSR BUS R
BUSM BUS MONO(L+R)
AUX AUX
? Return channel Input status
CONT constant
TRIG Trigger in
ASIG Audio signal
OFF Off
? Return Zone Turn On status
PBTN Power button
TRIG MASTER TRIGGER
ONLI ON LINE
? Return Power ON status
function
- 7 -
example
PW00ON<CR>
PW00STANDBY<CR>
PW00?<CR>
SV01DOWN<CR>
SV0180<CR>
SV01?<CR>
SO02NOR<CR>
SO02BRI<CR>
SO02?<CR>
SF05OFF<CR>
SF05ON<CR>
SF05?<CR>
SI06BUSL<CR>
SI06BUSR<CR>
SI06BUSM<CR>
SI06AUX<CR>
SI06?<CR>
ST08CONT<CR>
ST08TRIG<CR>
ST08ASIG<CR>
ST08OFF<CR>
ST08?<CR>
ST00PBTN<CR>
ST00TRIG<CR>
ST00ONLI<CR>
ST00?<CR>