IBM 88371RU Maintenance And Troubleshooting Manual page 32

Figure 12. Low-profile adapter installation, slot 1
10. If you have other options to install or remove, do so now; otherwise, go to
Installing an adapter into slot 2
Complete the following steps to install an adapter into slot 2:
22
xSeries 336 Type 1879 and Type 8837: Hardware Maintenance Manual and Troubleshooting Guide
6. Push the adapter down past the tab so that the adapter snaps into place on
the support.
7. Check the retention latches on the riser card and make sure that they are still
securely in place.
8. Connect any internal cables to the adapter. See the instructions that come with
the adapter for details.
Attention: Make sure that the cables do not block the flow of air from the
fans. See "System-board cable channels" on page 63 for cable routing areas
on the system board.
9. Perform any configuration tasks that are required for the adapter.
"Completing the installation" on page 47.
1. Read Appendix B, "Safety information," on page 129 and "Installation
guidelines" on page 15.
Attention: When you handle static-sensitive devices, take precautions to
avoid damage from static electricity (see "Handling static-sensitive devices" on
page 16).
2. Open the retaining clips on both sides of the slot 2 riser card. Push the clips
down, away from the riser card, until the clips are no longer attached to the
riser card.
Note: Insert your finger into the access hole on the slot 2 adapter cover to
open the retention latch at the rear of the server.
Figure 13 on page 23 shows the location of the access hole on the adapter
cover, the riser card and the riser-card retention latches.
Riser card
Low profile
adapter
Low profile
adapter support