Using The Scsiselect Utility Program (Scsi Models Only); Starting The Scsiselect Utility Program - IBM 84894MU User Manual

shown in the following illustration.
Complete the following steps to change the position of the clear CMOS jumper:
1. Review the safety information beginning on page v.
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Change the position of the clear CMOS jumper to bypass the user or supervisor
4. Install the riser-card assembly and the cover and connect the server to a
5. Turn on the server. You can now start the Configuration/Setup Utility program

Using the SCSISelect Utility program (SCSI models only)

Use the SCSISelect Utility program to configure SCSI devices. The SCSISelect
Utility program is available on SCSI models only.

Starting the SCSISelect Utility program

Complete the following steps to start the SCSISelect Utility program:
1. Turn on the server.
2. When the prompt <<< Press <CTRL><A> for SCSISelect Utility! >>> appears,
3. Use the arrow keys to select the channel for which you want to change settings.
4. When the prompt Would you like to configure the SCSI controller, or run
5. Use the arrow keys to select a choice from the menu.
6. Follow the instructions on the screen to change the settings of the selected
18
xSeries 306 Type 8836: User's Guide
Clear CMOS jumper (JP2)
external cables; then, remove the cover. Remove the riser-card assembly. See
the Option Installation Guide on the IBM xSeries Documentation CD for
instructions.
password check.
keyboard, monitor, and mouse; then, connect the server to a power source.
and either delete the old password or set a new user or supervisor password.
You do not need to return the jumper to the previous position.
press Ctrl+A. If you have set a supervisor password, you are prompted to type
the password.
the SCSI Disk Utilities? appears, make your selection and press Enter.
items, and press Enter.