Figure 3-4. Product Type Dialog Box
3 Select a Vendor. For each vendor, the supported product names appear in
the Product list. Select a product.
If the Remote Console Switch model you wish to add is not available in
the Product list, select Other. Once this switch is discovered, it will be
available in the Product list the next time you add a Remote Console
Switch.
4 Click Next.
5 You are prompted to indicate if the Remote Console Switch has an
assigned IP address. Click No and then click Next.
6 The Network Address window appears. Type the IP address, subnet mask
(if using IPv4 mode) or prefix length (if using IPv6 mode), and gateway
you wish to assign to the unit and click Next. IPv4 addresses are entered in
xxx.xxx.xxx.xxx dot notation. IPv6 addresses are entered in hexadecimal
FD00:172:12:0:0:0:0:33 notation or compressed FD00:172:12::33 notation.
NOTE:
The Remote Console Switch supports DHCP (Dynamic Host Configuration
protocol) and static IP addressing. Dell recommends that IP addresses be reserved
for each unit and that they remain static while the Remote Console Switch units are
connected to the network.
Basic Software Operation
21