Setting A Power Cap For A Group Of Servers; Setting A Bladesystem Enclosure Power Cap - HP Integrity NonStop NB54000c Introduction Manual

Setting a power cap for a group of servers

Insight Control is the sole tool for setting power caps for groups of ProLiant ML and DL servers. Using the Insight
Control interface (Figure 7), an administrator can apply a group power cap that is between the minimum power
and the power supply rating of the entire group.
Figure 7. Setting a group power cap in Insight Control

Setting a BladeSystem enclosure power cap

You can use either the OA or Insight Control to set the power cap for a BladeSystem enclosure to any value
between the power cap lower bound and the maximum available power for the enclosure. Figure 8 shows the
Power Management screen from HP Onboard Administrator. This screen is where you set the Enclosure Dynamic
Power Cap.
13