3. Slide the drive into the drive bay, then tighten the screws on either side
of the device.
Figure 3-14. Installing a tape drive
4. Connect the data and power cables to the back of the drive, as shown in
Figure 3-12.
5. Remove the two bezel blanks in the front bezel in front of the tape drive.
See "Removing the Bezel Blanks" earlier in this chapter.
6. Replace the access panel and the front bezel.
7. Restore power to the server.
Removing a Tape Drive or Other Device from the
Removable Media Bay
To remove a tape drive or other device:
1. Follow the steps in "Removing the Access Panel" at the beginning of
this chapter.
CAUTION: Before removing the access panel, make sure that the server is
powered down, all cables are disconnected from the server, and the power cord
is disconnected from the grounded AC.
Hardware Options Installation 3-15